Branch: refs/heads/ehb54-issue-984 Home: https://github.com/ehb54/ultrascan3 Commit: 21d60309ba107bfc69de60554c60a35ba4734d54 https://github.com/ehb54/ultrascan3/commit/21d60309ba107bfc69de60554c60a35ba... Author: ehb54 <brookes@uthscsa.edu> Date: 2026-08-07 (Fri, 07 Aug 2026) Changed paths: M us_somo/develop/include/us_hydrodyn.h M us_somo/develop/include/us_hydrodyn_save.h M us_somo/develop/src/us_hydrodyn_grpy.cpp M us_somo/develop/src/us_hydrodyn_save.cpp M us_somo/somo/doc/manual/somo/somo_hydro.html M us_somo/somo/doc/manual/somo/somo_save.html Log Message: ----------- somo/grpy: settings suffix on result files, GRPY options in the saved CSV Extends the shell-model naming of the previous commit to the .grpy_res and .grpy.csv result files, which had the same collision: a reduced and an unreduced calculation of one model, or two at different target accuracies, produced different numbers under the same name. Only non-defaults appear, so a run with shell reduction off in double precision writes exactly the names it always has. Also records the settings IN the saved file, which distinct names alone do not give you -- a new "GRPY options:" screen in the parameter selector with six entries: single precision, shell reduction, target accuracy, viscosity required, the estimated error achieved, and the quantity that error belongs to. Tabs are built from the section list, so the screen appears without a count to update anywhere. The estimated error is the one that matters. The CSV is what gets compared across runs, and until now it recorded the numbers with no uncertainty attached to them. These record the EFFECTIVE settings, not the dialog's: this_data.hydro now comes from a copy carrying any scripting or environment overrides, so a headless run reports what it actually used. Saving the dialog values would have been wrong precisely in the batch case where nobody would notice. FIX, found while checking this: used_beads was the count from setup, taken before any reduction, so a run using 2832 of 11328 beads reported 11328 in the CSV, the results table and the .grpy_res report line alike. Narrowed to what the ladder actually used, never widened, so shell-off runs are unaffected. Batch mode needs nothing: it enters through the same calc_grpy_hydro(), so the guard, the reduction, the cancellation and these names all apply, and the suffix is cleared at run start so a batch cannot inherit stale settings. Docs: somo_save.html goes from eight screens to nine, describes the six parameters, notes that the achieved error may exceed the target when stopped early or memory-limited, and records the used_beads correction. Fixes ehb54/ultrascan-tickets#984 Co-Authored-By: Claude Opus 5 <noreply@anthropic.com> To unsubscribe from these emails, change your notification settings at https://github.com/ehb54/ultrascan3/settings/notifications